thumbnail_wsg50_80x80
WSG 50
Sensitive electrical gripper with Ethernet TCP/IP and Profibus DP.

Read more...

DSACON32-H
DSACON32-H
The DSACON32-H is designed especially for the use with robot grippers.

Read more...

DSA 9205
DSA 9205i
Taktiler Aufnehmer mit integriertem Sensorcontroller, RS232 und CAN-Bus.

Weiterlesen...

Downloads

Application Notes

WRT-101 Firmware Update
WRT101_Firmware_Update.pdf (128.57 kB)
A step-by-step manual on how to update the Device Firmware for the tactile sensing system WRT-101 that is built into the SCHUNK SDH.
Configuring the DSACON32 over the built-in Shell Interface
DSACON32_configuration_shell.pdf (292.45 kB)
This document describes how to configure the DSACON32 family of grippers via the serial port using a VT100 compatible terminal connection. When using Windows, you may use the HyperTerminal Configuration File in this section to setup your terminal adapter.
HyperTerminal Configuration File
DSACON32.ht (27.51 kB)
The DSACON32 family of tactile sensing controllers can be configured via the serial interface using a terminal connection. This file contains the necessary configuration data for the HyperTerminal terminal emulation software that is delivered as a part of Microsoft Windows 2000/XP. Note: The configuration file assumes the DSACON32 to be connected on COM1.
DSACON32-H/-C Firmware Update Guide
DSACON32-H_firmware_update.pdf (110.33 kB)
This document describes how to update the device firmware of the DSACON32-C and DSACON32-H tactile sensor controllers.
Display Num